How modifiers are applied
SunSolve Power applies modifiers while preparing each cell’s equivalent circuit for the electrical solver. The sequence matters because modifiers scale the configured circuit after the optical result is assigned and before temperature correction.
Base circuits and sub-circuits
Section link: Base circuits and sub-circuitsSunSolve defines one base circuit for each electrical sub-circuit in the module. A single-junction cell normally has one base circuit, while a tandem cell can have one for each junction.
The Inputs → Cell tab defines which equivalent-circuit components are enabled and their base parameter values. Each modifier applies to one sub-circuit and can only vary parameters enabled in that circuit.
Creating per-cell circuits
Section link: Creating per-cell circuitsSunSolve creates a separate equivalent circuit for every cell by copying the applicable base circuit. This gives each cell the same starting configuration before cell-specific values are applied.
Assigning optical light-generated current
Section link: Assigning optical light-generated currentThe optical and calculations set the light-generated current for each cell. This replaces the base with the value calculated for that cell’s illumination and optical response.
Applying modifiers
Section link: Applying modifiersSunSolve then multiplies the targeted parameters by their modifier values. Multiple modifiers applied to the same parameter are multiplied together.
Changing a base value therefore changes the effective value produced by the same modifier. For example, a multiplier of produces different absolute values when applied to base values of and .
Applying temperature correction
Section link: Applying temperature correctionModifiers are applied at the nominal temperature . SunSolve then corrects the modified parameters for the operating temperature before solving the circuit.
Fitting, sweeps and optimisation
Section link: Fitting, sweeps and optimisationThe base circuit determines which parameters are available during fitting and supplies the values held constant while other parameters are fitted. A disabled component cannot be selected as a fitted parameter.
A sweep applies the same modifier configuration at every sweep condition. Modifier values cannot themselves be swept. An optimisation applies the same configuration to every run in each generation.