Slicing loss
Multi-cut modules divide each wafer into strips (for example half-cut, three-cut or four-cut cells) to lower the current per cell and reduce resistive loss. Cutting exposes new cell edges, and the recombination at those edges reduces cell performance. This penalty is the slicing loss.
SunSolve Power represents a sliced cell through its reduced dimensions and the larger number of cells in the module cell layout; it does not infer any electrical penalty from the cut itself. The optical and resistive benefits of slicing are therefore captured automatically, but the slicing loss is not. You add it explicitly through the equivalent circuit.
Representing slicing loss with J02
Section link: Representing slicing loss with J02Edge recombination is space-charge-region recombination, which the equivalent circuit carries in the second diode, J02. Increasing J02 raises the recombination current and lowers the fill factor, reproducing the effect of the added edge area.
To model slicing loss, raise the baseline J02 of the cut cells. The size of the increase is set from measured before-and-after cell data or from a known slicing-loss figure for the process, so it is an input to the model rather than a value SunSolve derives.
Applying the increase
Section link: Applying the increaseBecause the baseline J02 applies to every cell of a circuit, a uniform slicing loss is applied by scaling J02 with a single modifier targeting every cell, or by editing the circuit’s J02 directly. Running the simulation with and without the increase isolates the slicing loss from the current and resistance changes that slicing also produces.