Skip to content
Product

How to model module mismatch from distributions

Unlisted

This guide models the module-power and mismatch-loss distribution of a batch of modules by specifying how the cell electrical parameters vary. The variation is entered as uncorrelated parameterised distributions, using a target open-circuit voltage and fill factor together with a distribution of light-generated current.

To model module mismatch from distributions

Section link: To model module mismatch from distributions

Enable modifiers: On the Inputs → Options tab set a module-based Device configuration, enable the electrical solver, and enable electrical modifiers.

Choose the scope: On the Inputs → Modifiers tab, set the scope to Module population.

Choose the source: Set Distribution source to Parameterised distributions.

Set the population size: Enter the number of modules to build in the Modules field.

Add a light-generated current distribution: In the circuit section, tick Vary for JL, choose a distribution Type (for example Gaussian), and enter its mean and std dev as multipliers of the baseline.

Derive from Voc and FF: Tick Derive from Voc/FF distribution, choose the target parameters (J01 & J02 or J01 & Rs), then enter the std dev for the target Voc (V) and FF Gaussian distributions. Each target is centred on the value the circuit currently produces, which is shown beside the row as circuit.

Check the preview: Confirm the previewed Voc, FF, Vmp and Jmp histograms match the spread you intend before running.

Run the simulation: Click play.

Read the results: Open the distribution results tab to read the maximum-power and mismatch-loss distributions and download the population.